In half duplex mode, the error rate is less than 2%. Good-In full duplex mode, the error rate is less than 0.1%.Represents the ratio of the number or error packets on all the packets. Clicking on the device name will take you to the Device Details page.ĭenotes the switch port through which the wired client is connected to the network.ĭenotes the health status of the wired client. The network device to which the client is connected. The Wired client will display the port ID or the custom port name to which it is connected.ĭisplays the duration for which the client is connected to the network. Clicking on the network name will take you to the Network Details page.ĭenotes the device interface to which the client is connected. ![]() The network to which the client is connected. The client can either be an infrastructure client or a voice client.ĭenotes the MAC address of the wired client. Blank spaces and special characters are accepted as a valid characters in the client name.ĭenotes the type of the wired client. The length of the client name can be between 1 to 32 characters. The client name can be edited and updated to a custom name of your choice. Table 1: Wired Client Details Informationĭenotes the name of the wired client. The Client Details page for the wired client displays the following information: The Clients Details page for the wired client is displayed. Select a wired client from the list of Connected clients.Tap the Clients ( ) tile on the Instant On home page. ![]() To view the Client Details page for a specific wired client, follow these steps: Scenario 7: The wired device will be shown as a wired client.Scenario 6: The infrastructure device will be shown as an edge wired client.Scenario 5: The wired device connected to the third-party infrastructure device will not be shown as a wired client. ![]()
0 Comments
Leave a Reply. |